R.V.R. Elettronica TEX100, User Manual

Page: 16 / 48

TEX100
10 / 42 User Manual Rev. 4.0 - 18/07/03
Figure 5.1
Connect a switch, via a cable, to the BNC connector (REMOTE 3) on the rear panel
so that the switch is able to short the central conductor to its screen. Leave the switch
in the short-circuit position. It is not indispensable to have a cable of this type, but it is
comfortable when is wanted to able or to disable fastly the emission of power is
wanted.
Verify that TEX100 is switch off.
Connect line power to the unit via the VDE socket.
NOTE: This device shall be correctly connected to ground. Correct grounding is
essential both for safety and to reach the rated performances.
5.2 Use
Select the desired operating frequency using the corresponding selector. The
frequency selector comprises five figures of which the three to the left of the decimal
point represent (from left to right) hundreds of MHz, tens of MHz and MHz. Examples
of right configurations are:
0 9 8 4 5
98.45 MHz
1 0 3 9 0
103.90 MHz
Furthermore, if a frequency is selected beyond the two limits of the 87.5-108 MHz
band, the amplifier will continue to work even through the displayed frequency no
longer corresponds to the operating frequency of the unit.
NOTE: Transmitting outside the legal band (87.5-108 MHz) is an offence and may
lead to prosecution. For this reason, the TEX100 can be equipped on demand with
a device that prevents the transmission on various frequencies from those concurred.