6 / 22
User Manual
Rev. 1.0 - 28/09/07
TCP/IP-INT-TEX
2) If the
User Name
and the
Password
have not been entered and saved yet,
and if no changes were made to access modes, enter
RVR
and
RVR
to enter
as administrator (if access data were modified, enter the new
User Name
and
Password
). Then click on
Login
.
Note :
To enter as user, type
user
and
user
into
User Name
and
Password
fields.
This enables WUI read-only mode.
3) Now interface is ready to remotely read data and modify the various settings
of the equipment.
5.3 Management Software
1a) After access is made, the
Main menu
(main page) opens and shows
possible viewing options. This picture shows the
Main menu
after access as
administrator:
Main menu
Device
Show all the device information
Device status
Read all the device data and navigate to the showing page
Device settings
Allow the user to change the device settings
Alarms
Show the last ten active alarms
Network settings
Allow you to set up the network parameters
General settings
Allow you to set up all the parameters for the application behaviour
Commands
Allow you to perform command on the TCP/IP interface
Menu 2
1b) If you enter as user, with no administrator privileges, only reading functions
will be available within the
WUI
, and the
Main menu
will be like this:
Main menu
Device
Show all the device information
Device status
Read all the device data and navigate to the showing page
Device settings
Device settings
Allow the user to change the device settings
Alarms
Show the last ten active alarms
Network settings
Network settings
Allow you to set up the network parameters
General settings
Allow you to set up all the parameters for the application behaviour
Commands
Allow you to perform command on the TCP/IP interface
Menu 3
