4 / 8
User Manual
Rev. 1.0 - 06/02/09
IBJECT12K10A & IBJECT12K10B
5. Installation and configuration procedure
This section provides a step-by-step description of equipment installation and
configuration procedure. Follow these procedures closely upon first power-on
and each time any change is made to general configuration, such as when a new
transmission station is added or the injector is replaced.
Once the desired configuration has been set up, no more settings are required
for normal operation.
The topics covered in this section are discussed at greater length in the next
sections, with detailed descriptions of all hardware features and capabilities. Please
see the relevant sections for additional details.
IMPORTANT:
When configuring and testing the injector in which the equipment is
integrated, be sure to have the Final Test Table supplied with the equipment ready
at hand throughout the whole procedure; the Final Test Table lists all operating
parameters as set and tested at the factory.
5.1 Preparation
5.1.1 Preliminary checks
Unpack the
IBJECT12K10
and immediately inspect it for transport damage. Ensure
that all connectors are in perfect condition.
Provide for the following (applicable to operating tests and putting into service):
√
Connection cable kit including:
• Cables, with connector 1+5/8“ (not included), between
IBJECT12K10
and
sources of FM analog transmission, and between
IBJECT12K10
and output
in antenna.
• Cables, with connector 7/16 DIN (not included), between
IBJECT12K10A
and
sources of IBOC digital transmission, and between
IBJECT12K10A
and output
in dummy load. If you are using the
IBJECT12K10B
version, use cable with
connector 7/8 EIA.
The
IBJECT12K10
must be installed on a rack that includes an anti-strap device
to prevent the possibility of accidental disconnection of feeding conductors.
Warning: Disconnect mains power supply before beginning these
procedure.