R.V.R. Elettronica BLUES 30, User Manual

Page: 18 / 32

BLUES30
14 / 28 User Manual Rev. 1.3 - 16/10/03
On accessing this screenful, the cursor blinks on the MHz frequency value: turn the
knob for selecting the required frequency from 87 to 108 MHz and then press the
encoder to confirm.
Now the cursor blinks on the order of kHz: repeat the same operation previously
described to execute fine frequency selection .
On completing settings, the cursor blinks on the arrow. Press arrow to access the
menu for confirming or not new frequency:
Select "Yes" to confirm, the "LOCK" LED on the front panel will go off for a few
seconds until the VCO does not lock the new set up frequency .
6.1.3 Channels menu
The instantaneous levels of the inputs of the right and left channels are shown by
means of horizontal bars as shown in the figure.
The empty rectangle indicates level that it corresponds to the total variation of 100%
reported to every channel.
6.1.4 Unclipped Menu
This menu shows, through an horizontal bar, the modulation level with limiter of
modulating signal disable.
The empty rectangle in the bar corresponds to the 75 kHz deviation level.