PTRLNV/4 & RXRLNV/4
ELETTRONICA
2
/ 34
User Manual
Rev. 1.0 - 09/06/10
The above line displays the instantaneous reading of the signal level received on
analog scale.
To change the set muting level, keep the ENCODER pressed for about 5 seconds
until it enters the modification mode.
The screen that is shown in the modification mode is similar to the following:
RF : -100 dBm
Mute: -95 dBm
Menu 2
The upper line is a reading of RF level, while the bottom line gives the instantaneous
reading of the muting level. To increase the muting level rotate towards clockwise,
to reduce it rotate towards counter-clockwise. When the desired level is reached,
press the ENCODER to confirm and exit to the predefined menu. Note that the
set value is stored anyway, so if you pass the time-out without pressing a key, the
power will remain at the last set level.
The first pressure of the ENCODER when the display is light out, or its rotation,
serves in order to activate the retroillumination.
The pressure of ENCODER when the display is switched on, while you are in the
predefined menu, serves in order to shown the following selection screen from
which you can access to all the other menus:
General Setting
Audio Setting
Levels Meters
About Version
Exit
Menu 3
If you instead want to go back to the predefined menu, is sufficient select the ESC
entry then push the ENCODER.
To enter into one of the submenus, select its entry (which will be underlined by a
blinking cursor) with the rotation and then press the ENCODER.
Figure below shows the complete set of the equipment menus.
