5
Pulse Amperage Range
5 - 95%
Gas Post Flow Time
0 - 50 Seconds
Gas Pre Flow Time
0 - 25 Seconds
Arc Starting Mode
High Frequency
AC Waveforms
Advanced Squarewave
Soft Squarewave
Triangular
Sine Wave
AC Balance Control
5 - 90% of Electrode Positive
AC Easy Start Parameters
AC Frequency 120Hz
AC Balance 25%
Pre flow Gas .5 seconds
Post Flow Gas 4 seconds
Main Amps 120A
Start/End Amps 50A
Upslope 1 seconds
Downslope 3 seconds
DC Easy Start Parameters
Pre flow Gas .5 seconds
Post Flow Gas 4 seconds
Main Amps 90A
Start/End Amps 50A
Upslope 1 seconds
Downslope 3 seconds
Gross Weight
22 KG
Insulation
IP21S
Dimensions mm
438H x 232W x 550L (mm)
Safety Precautions
Read entire section before starting installation
WARNING!
Electric Shock can kill
– Only qualified personnel should perform this installation. Turn off input
power at the fuse box before working on this equipment.
Do not touch electrically live parts. Always
connect the machine to an earthed mains supply as per national recommended standards.
Select suitable location
Place the welder where clean cooling air can freely circulate in and out of the front & rear louver
vents. Dirt, dust or any foreign material that can be drawn through vents into welder must be kept to
a minimum. Failure to observe these precautions can result in excessive operating temperatures
which can lead to plant failure.
Grinding
Do not direct grinding particles towards the welder. An abundance of conductive material can cause
plant failure.
Stacking