![background image](http://html.mh-extra.com/html/r-tech/mts-450/mts-450_operation-instructions-manual_775161011.webp)
11
2.
Wire feed control – This will change wire feed speed and will be shown in amperage
display as value in display for reference purposes.
3.
Connect euro type MIG torch – Ensure pins are located first then tighten securely
4.
Water cooler connectors (optional when water cooler fitted) – Connect 2 x water cooler
hoses from water cooled torch.
Blue = water out – cooled water from water cooler
Red = water return – to be cooled
5.
Gas hose connection – Connect 3/8 BSP nut on end of 5M interconnection cables to
gas regulator (not shown)
Connect the gas input hose to gas regulator, Set gas flow/pressure to 10-14 LPM, In a
drafty or open areas a higher flow may be required to stop porosity of weld.
Make sure gas bottle is secured machine securely to avoid injury.
Controls and Settings
1.
Voltage LED – This meter can show actual welding voltage and preset welding voltage
in increments of 0.1v. It indicates preset voltage during no welding.
2.
Current LED – This meter shows actual welding current during welding and indicates
the preset speed of wire feeding during no welding.
3.
Welding current control knob for MMA welding, It can be set between 40-450Amps
4.
Burnback adjustment - Burnback adjustment – This sets amount of time welding power
stays on after torch button released and wire feed has stopped. If too little Burnback is
set, wire may stick to work after trigger released, if too much Burnback is set wire will
Burn back into welding tip.