Version 11.09.2020
HW: CAM(V100)/(V52)
RL4-NAC
P
a
g
e
7
1.5.
Connectors - Video-Interface
The video-interface converts the video signals of connected after-market sources in a factory
monitor compatible picture signal which is inserted in the factory monitor, by using separate
trigger options. Further it reads the vehicle’s digital signals out of the vehicle’s CAN
-bus and
converts them for the video interface.
1.6.
Settings of the 8 Dip switches (black)
Some settings have to be selected by the 8 dip-switches at the
video-interface. Dip position down is ON and position up is OFF.
See the following chapters for detailed information.
After each Dip-switch-change a power-reset of the Can-box has to be performed!
Dip
Function
ON (down)
OFF (up)
Power supply
output
(red wire)
+12V (max. 3A) when reverse gear
is engaged incl. 10 seconds delay
and +12V by manual switching to
front camera by keypad
+12V (max. 3A) ACC
2
CVBS AV1-input
enabled
disabled
3
CVBS AV2-input
enabled
disabled
4
No function
Set to OFF
5
Rear-view cam type
after-market
factory or none
6
Frontcam
back-switching
for 10 seconds
enabled
disabled
7
No function
Set to OFF
8
Head-unit version
Continental HU as Low Version
(single black 4pin HSD)
Bosch RCC-A1 HU without
navigation as Low Version
(single black 4pin HSD)
Continental HU as High Version
(double black 4pin HSD)
Bosch RCC-A2 HU with navigation
as Low Version
(single black 4pin HSD)
