19
BA_BM_HS-200_EN_43-21.docx
11
Maintenance and Repair
Maintenance and repair work may only be carried out by competent, trained and instructed personnel. If nec-
essary, further operating instructions and/or additional documents must be observed.
After maintenance or repair work on the lift table, always carry out a function test.
•
It is forbidden to reach under the lift table platform before it is secured
with the safety catch (see
section 11.1).
•
Wear safety shoes with steel-toed caps.
•
Wear suitable protective clothing.
Repair work on mechanical and hydraulic components may only be carried out by authorised
and trained personnel.
Before any maintenance and repair work is carried out, chapter
4 "Safety" must be read
carefully and observed.
11.1
Safety Catch for Securing
Figure 5: Safety catch for securing
The safety catch is primarily used for securing during maintenance work
that has to be carried out underneath the lift table platform. This mainly
includes replacing the hydraulic cylinder.
Since the lift table can no longer be held when the cylinder is removed, it
can fall dangerously. For this reason, the safety catch must generally be
used during maintenance work in the scissor area and underneath the
platform.
To secure the lift table platform, lock the safety catch (
7
) by folding it down
(see
11.1.1
Replacing the Hydraulic Cylinder
Move the lift table upwards until the safety catch (
7
) can be folded down. Then fold down the safety catch to
secure the platform (see previous section
11.1). Subsequently lower the lift table until the safety catch is
effective and the hydraulic cylinder is relieved resp. accessible for removal.
Stop! Do not work under the lift table platform until it is mechanically locked via the safety catch.
Non-compliance can result in life-threatening injuries.
11.2
Maintenance Intervals
Interval Action
Daily
Check all components for damage and have them replaced by competent personnel if neces-
sary. If you have any questions, please contact our support (phone: 0049 7576 / 962 978 - 0).
Monthly
Lubricate the castors and bearings a little.
Annual
Make and document annual inspection of the lift table according to regulations.
7
