Qwic Premium MN7D, Manual

Page: 41 / 74

41
NE
DE
RL
AND
S
ENGLI
SH
DEU
TS
C
H
5. COMPONENTS
the brakes. Moreover there is a chance that the brake pads can squeak
while braking. If you have problems with squeaking brakes, replace
your brake-pads, clean your disc appropriately and redo the burn-in
procedure.
Burn-in requires a dry and clean environment. Accelerate to 20km/h and
gradually brake on 1 brake unti l standsti ll. Repeat 20 ti mes for front and
rear brake separately.
bell
We advise you to familiarise yourself gradually with the full stopping
potenti al of your bike. In that way you are preparing yourself for an
eventual emergency stop without loosing control of your bike.
bell
A full stop on a front- or rear-brake alone could potenti ally
make you loose control of your bike. Always make use of both
brakes simultaneously. For very strong braking keep your arms
straight and your weight back to counteract potenti al ti lti ng of the
bike.
5.3. Gears
Shimano gear hubs
The Premium MN7 is equipped with a Shimano Nexus 7 gear hub. It is
a 7 gear, low maintenance hub that provides you with a gear rati o of
240%. You can easily change gears by rotati ng the gear shift er.
5.1. Lights
You can easily switch the lights on and off by pressing the appropriate
butt on on the controller as shown below.
The colour TFT display also has a light sensor. The sensiti vity of the light
sensor can be set by your dealer. If you manually turn your light on or off ,
the light will not turn on automati cally anymore unti l you restart your
display.
5.2. Brakes
To prevent any surprises while driving, please familiarise yourself which
brake lever operates which brake (front and rear). It is important to never
apply any grease or cleaning agents on braking pads or rotors as it can
cause noise while braking and diminish braking functi onality.
Hydraulic Disc brakes
Disc brakes combine high braking power with a high level of control.
The brake pads of the hydraulic disc brakes can be adjusted by slightly
loosening the hexbolts of the caliper mount. Center the caliper while
pulling the brake levers fi rmly. Tighten the screws fi rmly while keeping
pressure to the lever. If this fails, consult an expert.
Burn-in procedure
Disc brakes from Shimano require a burn-in procedure. By not doing
the burn-in procedure, you will not reach the full stopping-potenti al of
14
5
RANGE
km/h
30 km
4
Hold
+ butt on (2 sec)
to switch on lights
Hold
butt on (2 sec)
to switch on lights