Qwic Compact FN7, Manual

Page: 51 / 120

51
NEDERLANDS
ENGLISH
DEUT
SCH
Display & Controls: Models with a 6 level display
Controls
On / Off switching
Switch the display ON and OFF by pressing the ‘PLUS’
button a little longer. The system will shut itself down
after 10 minutes not being used to save energy.
Lighting
By pressing the ‘LIGHT’ button shortly the lighting
will switch on or off. The indicator next to the ‘LIGHT’
button shows the status of the lighting (on or off).
Battery indicator
Every round of the battery status indicator is about 25%
of the total battery capacity. With 4 rounds the battery
is 75-100% full. When the battery status indicator
shows no rounds, the motor will smoothly cease
assistance.
Power level indicator
The power level indicator shows which assistance
level you are in. There are 6 different power levels and
a ‘0’ level. In level 0 the motor offers no
assistance but the lighting and the Walk-assist are still
available. You can adjust the assistance levels with
the ‘PLUS’ and ‘MINUS’ buttons.
Walk-assist
The walk-assist function enables by keeping the
‘MINUS’ button pressed.
Failure codes
It is possible that failures occur. If this happens, go to
the dealer as soon as possible so repairs can be carried
out quickly. The following codes can be displayed on
the display:
LED 1 blinking: Problem with the controller
LED 2 blinking: Problem with throttle connection
LED 1+2 blinking: Motorcable 3-phase wiring loose or
defective
LED 3 blinking: Motorcable Hall Sensor signal
malfunction (malfunction in motor or
motorcable loose or damaged)
LED 1+3 blinking: Malfunction in brake sensor(signal)
LEDs 1,2 and 3 blinking at the same time:
Communication problem
(defective cable, controller or display)