The dome conducts self-testing after current-carring,and it rotates slowly until displaying pan origin
that is default setting, then moving to tilt origin, when self-testing is finished, there is relevant system
information displaying on the screen, as follows:
5. 1. 2 Call the main menu
The system enters into the main menu by 95preset or twice transfer 9 preset in 3 seconds . All the menu
setting must enter into the main menu at first.
Ø
Keyboard operation
：
【
OPEN
】
，
it means to enter the next menu or enter into setting, or save after
finish to set.
【
CLOSE
】
，
it means to close to cancel, or exit to the former menu.
【
】
.
【
】
Press
【
TELE
】
and
【
WIDE
】
at the same time, it means 3D joystick rotates joystick cap.
Ø
Menu operation
：
“
BACK
”
: Back to the former menu.
“
EXIT
”：
Exit to menu
“
ON
”：
Open some setting
“
OFF
”：
Close some setting
The information will not disappear until you stop to operate the system. If you set
“
power up action
”
,
the dome will automatically activate motions after self-testing. How to operate the function? We will explain
detail introduction in following passages.
when choosing menu
when choosing menu
Joystick to up: When choosing menu, it means to choose the former one; when choosing picture, it
means camera tilt up.
Joystick to down: when choosing menu, it means to choose the next one; when choosing picture, it
means camera tilt down.
Joystick to left: when choosing menu, it is equal with
Close
, when choosing picture, it means
camera tilt left
Joystick to right: when choosing menu, it is equal with
Open
, when choosing picture, it means
camera tilt right.
5. 1 Basic operation
5. System setting
5. 1. 1 Power up and self-testing
5. 1. 3 Menu and keyboard operation
DOME S/N:
VERSION:
DOME S/N:
VERSION:
PROTOCOL: FACTOTY
PROTOCOL: FACTOTY
DOME ID
：
001
DOME ID
：
001
BAUD RATE: 4800bps
BAUD RATE: 4800bps
MODEL:
MODEL:
Software version
Protocol
Dome ID
Communication parameter
Serial number of the dome
Model
5
System setting
6
System setting
5. 3 Dome initial information
1. Call
2.
to
SYSTEM
, press
to enter submenu.
3.
to
DOME INFO
, press
to display initial information
as the left picture shows.
Initial information includes S/N of the dome, soft edition,
protocol, dome ID, communication parameter. SYSTEM may
change the numerical value of initial information.
95 preset or transfer 9 preset twice in three seconds to enter
the main menu.
【
】
【
OPEN
】
【
】
【
OPEN
】
Operate the joystick up and down and move the cursor
Operate the joystick up and down and move the cursor
DOME INFO
DOME S/N: 0001
VERSION : V1.00
MODEL :DOME
PROTOCOL:PELCO
DOME ID
：
001
BAUD RATE
：
4800bps
BACK
EXIT
SYSTEM SETTING
DOME INFO
ID SETTING
AUTO RUN
DEFAULTS
BACK
EXIT
MAIN MENU
SYSTEM
CAMERA
FUNCTION
INFRARED LED
ALARMS SETUP
EXIT
