© Copyright Qvis ®. All documentation rights reserved.
13
Figure 3-4
3.2
Restore Factory Default Setup Introduction
Important:
Please use RESET button when device is running.
Step1:
Please refer to Step 1 and Step2 in Chapter 3.1 to loosen the dome body. Push a little bit; you can
take the dome body from the dome cover.
Step2:
Take the dome body out and then turn the top cover hard to remove.
Step3:
Slightly press the RESET button to complete the reset function (see Figure 3-5).
Step4:
Turn the top cover back to the original position. Please make sure it reaches the original position,
otherwise it may result in water leaking into the housing!
Step5:
Put the dome back to the dome cover. Please refer to Step 4 in Chapter 3.1 to install the decoration
ring back.
Figure 3-5
