© Copyright Qvis ®. All documentation rights reserved.
7
3
Device Installation
3.1
Installation Steps
Important:
Before the installation, please make sure the installation environments can support at least 3x
weight of the camera.
Please follow the steps listed below to install the device. Please refer to Figure 3-1 for reference.
Step 1:
Turn clockwise to remove the decoration ring from the snap joints.
Step 2:
Please take out the installation position map from the accessories bag, and then paste it on the
ceiling or the wall according to your monitor area requirements. Draw and then dig three plastic expansion
bolts holes in the installation surface and then insert three expansion bolts in the holes. Secure these three
bolts firmly. Please draw the cable out from the cable exit when you install the device.
Step 3:
Adjust the device installation pedestal to the proper position and then line up the three screw holes
in the device pedestal to the three plastic expansion bolt holes in the installation position. Put the three self-
tapping screws in the three plastic expansion bolts firmly. Loosen the M3X8 cross recessed pan head slot
screw of the pedestal to unfasten the preforming. (Do not remove, loosen a little bit will be OK.). Adjust the
lens to the proper monitor angle and then use the original preforming to turn the M3X8 cross recessed pan
head slot screw back.
Step4:
Line up the three spigots of the decoration ring to the jags from the bottom to the top and then turn
clockwise until you hear a clear sound
”KA”. Now the installation is complete.
Figure 3-1
Summary of Contents for AMB-EYE1.3
Page 2: ...i...