WARNING
Always make sure that the installation surface or mast can carry the weight of the
equipment and possible wind loads before installation.
Installation Tips
●
When installed outside,
install the device tilted
to allow rainwater to run off the device.
●
Carry out a
test installation
before ordering all of the installation parts for a larger project.
●
Please check the local authorities’ safety requirements and if necessary,
use a safety wire
to
ensure a safe installation.
●
If the Q35 needs to be tilted to achieve the intended coverage area, make sure to
mount the
device so that the required mechanical tilt can be achieved
.
●
When installed outside, please consider using an additional
surge protector
to protect the
device
.
5.2.
Connect to Power Supply
Option 1: Use Power over Ethernet (PoE)
The Q35 supports the use of standard IEEE 802.3at Type 1 PoE components, e.g. PoE switch or power
injector, as its power source. Only use standard certified PoE devices. When using PoE, a separate DC
power supply is not required.
Option 2: Use Separate 5V DC Micro USB
If you are not using PoE components, connect the Q35 to a 5V power supply with a Micro USB. Only use
compatible power supplies. Contact Quuppa in case of any uncertainty regarding compatible power
supplies.
When the power supply is connected, the Q35 automatically switches on. The red indicator light flashes
multiple times, after which the red indicator light remains on statically until the Q35 is connected to the
QPE.
5.3.
Connect to Network
9/21
Quuppa Q35 Locator Installation Guide and Safety Information
Quuppa Oy, Keilaranta 1, 02150 Espoo, Finland
© 2020 Quuppa Oy
Customer Confidential
