2
4
1
3
1. Connecting tank
Place the tank in position and connect
the inlet hose to the inlet combination with
the large fibre washer supplied. Connect
the tap hose to the fitting at the top of the
tank using the small washer and size 10
and 14 spanners.
2. Electrical connection
Connect the boiling-water tap by plugging
the LED cable into the hole provided at
the back of the tank cover. Connect the
tank to the socket. Switch the socket on
but not the tank yet.
3. Filling tank
Open the boiling-water tap and the stop
valve on the inlet combination. Check
for leaks. Flush the tank through until the
water is clear. Black water will flow out
initially. This is Norit carbon from the filter
and completely harmless.
4. Switching on tank
Switch on the tank. After the water has
heated up, the entire content of the
Quooker must be flushed out once
before use.
E
Connecting tank
• The Quooker tank is supplied with a UK 3 pin plug and requires a standard 13 amp
earthed socket.
• If the mains lead is damaged it should be replaced by the manufacturer, their agent or a
qualified technician to prevent hazard.
• The light ring on the boiling-water tap will light up to indicate when the water is being heated
inside the tank.
• The Q-shaped button on top of the tank is the on/off switch. Once the water is up to
temperature the light on the tank will fade in and out.
• Ensure that the tank has sufficient height clearance to avoid pinching the hose.
• Do not use any other washers or sealants than the ones supplied.
COLD
10
14
COLD
On/off
