Quonset Microwave QM1013-102, User Manual

Page: 41 / 91

QM1013-102 0.001-6 GHz Dual Channel Upconverter User Manual
1.4 STATus Subsystem
Table 4.4: STATus Subsystem Commands Summary
Command Page Description
STATus:OPERation 41 Returns the contents of the status event register.
STATus:OPERation:CONDition 42 Returns the contents of the condition register.
STATus:OPERation:ENABle 43 Sets the enable bit mask for the status event register.
STATus:PRESet 44 Presets the STATus:QUEStionable:ENABle register.
STATus:QUEStionable 45 Returns the contents of the questionable register.
STATus:QUEStionable:CONDition 46 Returns the contents of the questionable condition reg-
ister.
STATus:QUEStionable:ENABle 47 Sets the enable bit mask for the questionable register.
1.5 SYSTem Subsystem
Table 4.5: SYSTem Subsystem Commands Summary
Command Page Description
SYSTem:BOOTstate 48 Specifies a state to boot to at device startup.
SYSTem:CURRent 49 Returns the current draw of the device.
SYSTem:ERRor 50 Returns error numbers and messages from the error
queue.
SYSTem:FIRMware 54 Returns the current firmware version of the device.
SYSTem:LOADstate 55 Loads and sets the parameters from the specified
state.
SYSTem:OPTions 56 Returns the configured options of the device.
SYSTem:READstate 57 Reads the parameters from the stored state without
changing the current device setup.
SYSTem:SAVEstate 58 Saves the current parameters to a specified state num-
ber.
SYSTem:SERialNUMber 59 Returns the serial number of the device.
SYSTem:USBPID 60 Returns the USB PID of the device.
SYSTem:VERSion 61 Returns the version of SCPI implemented in the 0.001-
6 GHz Dual Channel Upconverter.
Quonset Microwave Revision 1.2.0 30