7
Connecting the water supply pipe
Follow your water supplier’s instructions.
For connection information, see the data
plate/technical specifications
Use a reinforced hose (not supplied) with a
standard connection (ext. diameter:
16mm/int. 12mm, maximum length: 25m).
IMPORTANT!
Only use water without
any impurities. If there is a risk of sand
particles in the inlet water (i.e. from your
own well), an additional filter should be
mounted.
Let the water run through the water hose
before connecting it to the machine to
prevent sand and dirt from penetrating the
machine. Note: Check that the filter is fitted
in the water inlet pipe and that it is not
clogged up.
Connect the water hose to the water supply
by means of the quick connector (inlet
water, max. pressure: 145psi, max.
temperature: 40°C).
Turn on the water.
The trigger gun (1) and lance is affected by
a thrust during operation - therefore always
hold it firmly with both hands.
Plug the power cord into a grounded 120V
outlet, that is on a dedicated circuit. Do not
use extension cord. Press the reset button on
the GFCI plug adapter. This must be done
each time the unit is plugged into an outlet.
Grounded plug/reset button
IMPORTANT: Point the nozzle at the
ground.
Check that the machine is in upright
position. NOTE: Do not place the machine
in high grass!
Release the trigger lock.
Activate the trigger of the trigger gun (1)
and let the water run until all air has
escaped from the water hose.
Press the Start/stop switch (7).
Activate the trigger of the trigger gun (1).
Always adjust the distance and thus the
pressure of the nozzle to the surface, which
is to be cleaned.
Do not cover the machine during operation
or use it in a room without adequate
ventilation!
NOTE:
If the machine is left or not used
for 5 minutes, it must be switched off on the
start/stop switch (7) "O":
To stop:
Press the start/stop switch (7) "O".
Disconnect the electrical plug (12) from the
socket.
Shut off the water supply and activate the
trigger of the trigger gun (1) to relieve the
machine of pressure.
3.4 Water connection
3.5 Start/stop the machine
1
2
A
3
12
