To remove the component rack assembly -
see
Figure 2
:
. Unplug power cord from the internal outlet.
. Remove the
lower
5-pin connector.
3. Disconnect the flag bracket(s) from the door
bracket.
4. Loosen the two () 7/6” nuts at each end of
the component rack.
5. Remove component rack assembly by sliding
rack to the right and lifting out.
Please refer to the TROUBLE SHOOTING
CHARTS (pg. 5-7) in this manual for additional
information on the window adjustments or ser-
vice procedures.
Contact us at
(800) 388-8307
for assistance or
for information on the nearest service center in
your area.
Figure 2
CAUTION:
Power Supply = 0 V
Warning:
For your own safety, turn power
switch OFF before removing access panel
Service Manual
SST-4035E
3
Quikserv Corp.
©
quikserv.com
• -800-388-8307 • Fax (73) 849-5708
Component Rack Assembly
