QK-KEY
Installation Guide
3
Programming:
100 memory cells 8 digits long each one, available.
Cell 00 is used for door opening times values storage.
Cell 99 is used programming code value storage.
The rest of the 98 cells from 01 to cell 98 are used for different access codes values storage.
Code length is minimum 2 digits and, maximum 8 digits. (Recommended 6 digits for
programming code, and 4 digits for access code)
Programming code, access codes and opening times values are programmable via the
keyboard.
Programming mode: in order to store new access code, set opening times or changing the
programming code, you should enter to the Programming mode.
After clicking the valid programming code (manufacturer code if not changed is
⇒
123456
confirm with
*
) the green led is blinking, now you can do the required programming as
described in the following examples. When finished you can enter more access codes or exit
this mode to the regular state by typing
#
.
Each key stroke is followed by a Beep sound, entering a false code or invalid typing is
followed by a “Beep-Beep-Beep” sound sequence. Entering a valid sequence to memory cell is
followed by a long “Beep” sound.
If the programming mode is not exit. A timer exits the encoder to regular mode.
Examples:
Storing a new access code
Enter the programming code: if not changed is: 123456 confirm with
*
, the green led will
blink.
now the following sequence should be entered: memory cell number (2 digits), access code
(2-6 digits),and for verification again the same memory cell number, the same access code.
Confirm with
*
. To finish press:
#
.
You can add more access codes in cells 01-98 in the same way.
-
to use the access code: press the access code followed by
*
.
Changing the programming code
Enter the programming code: if not changed is: 123456 confirm with
*
, the green led will
blink.
now the following sequence should be entered: memory cell number 99 , new programming
code ,and for verification again the memory cell number 99, the same new programming
code. Confirm with
*
.
Now you can add access codes in cells 01-98 as described or exit.
To finish press:
#
.
You should keep this code because this is the only way to enter the programming
mode!
Back to Initiate status – default
Using an internal jumper the initial programming code can be restored. The access codes will
not be changed.
Turn the power off. Dismount the panel. Install a jumper on pins labeled:
DEFAULT
turn on
the power, a long “Beep” will be sound for confirmation.
Turn off the power and take out the jumper. Reinstall the panel.
The encoder returns to normal condition. The Programming code now is: 123456 *.
Canceling an access code
A particular access code could be cancel if its memory cell location is known.
Enter the programming code: if not changed is: 123456 *, the green led will blink.
now the following sequence should be entered: memory cell number to cancel(2 digits), and
# #
.for verification again the same memory cell number, and
# #
. Confirm with
*
.
For example: canceling the code stored in cell number 37:
press the following sequence:
⇒
37,# #,37, # # *.
To finish press:
#
.
