Pool assembly / Fitting assembly
9
Step 7:
Pull grids under liner outwards. Insert “U tubes” in every grid and place a “U tube connector” on each
end of the “U tube”. Two people should lift one short lateral top rail of the pool while a third person
places the tip of the “U tube connectors into the corresponding holes in the underside of the top rail. The
pool will remain standing, which will make it easier to fit the rest of the “U tubes” into the top rail.
Special note:
Once you finish, make sure the liner fits comfortably on the structure. Go around the pool
to check that the framework is assembled correctly. Once you start filling the pool with water, you will not
be able to make any changes.
IMPORTANT: Make sure to place a support base of concrete or treated wood under each vertical
upright as correctly shown below.
GROUND
Base
Base
Step 8:
Now that you’ve completed the pool assembly, its time to install the skimmer and return fittings. Follow
the diagram below. Once the skimmer has been properly assembled, insert the 2 skimmer straps
through the openings on the skimmer and buckle them securely to the loops on the pool liner.
Gate Valve
(optional)
Compression
Nut
Gasket
Liner
Compression
Face
Skimmer
Gasket
Summary of Contents for QS 142248
Page 11: ......
