18
ELECTRIC TIPPER TRAILER INSTRUCTION MANUAL
4. Repair or Replace
4.1. During the warranty period, Quik Corp or
its authorised Dealer/Service Agent shall
repair or replace, at Quik Corp’s discretion,
without charge for parts and standard
labour, any part of the Quik Corp Product
which fails because of defects in material
or workmanship unless the damage arises
from:
4.1.1. Failure resulting from neglect or misuse,
such as improper operation, lack of
required maintenance or continued use of
the Product after the discovery of a defect
which results in greater damage to the
Product;
4.1.2.
Deteriorated or failed components
such as but not limited to diaphragms,
O-rings, hoses, seals, electrical wiring
and connections damaged by corrosive
chemicals, dirt and sand, excessive heat or
moisture. The Customer should ensure the
type and strength of chemicals used in the
Product are compatible with the design of
the Product;
4.1.3. The use of accessories, hardware, or
software which were not manufactured
by, installed by or approved in writing by
Quik Corp;
4.1.4. The use of consumable items such as but
not limited to oils, lubricants, diaphragms,
O-rings, hoses seals, gaskets, filter
elements, flow meters, clutches, drive
belts, pivot pins, paint, batteries, radio
transmitters, radio relays, push buttons,
switches, hose rollers, aerials, spray
guns and nozzles as these items are
considered to be normal wear items and
are not warranted;
4.1.5.
Component failure caused by not
performing scheduled maintenance
service such as oils, grease, failure to
clean tanks, pumps, filters, spray lines,
nozzles or any other components and not
tightening or replacing loose or missing
bolts, nuts, fittings, shields and covers
4.1.6. Damage or machine failure caused by
carelessness or accidental damage,
improper operation, inappropriate
transportation or storage of the Product
4.1.7. Any contamination or leakages caused or
induced by the Customer
4.1.8. Any use or operation of the Product
outside the physical, electrical or
environmental specifications of the
Product
4.1.9. Any
alterations,
modifications,
attachments or unauthorised repairs
to the Product which have not been
authorised in writing by Quik Corp; and
4.1.10. Failures due to faulty or inadequate
electrical sources of power
5. OEM Warranties
5.1.
All OEM (Original Equipment Manufacturer)
components are covered by the Original
Manufacturer’s Warranty. It is the
Customer’s responsibility to familiarise
themselves with these warranties, and
subject to clause 7, that is the only warranty
given to the customer in respect of that
part of the Product.
6. Statutory Rights and Exclusions (New Zealand Only)
6.1. If the Product has been acquired for the
purposes of a business then pursuant to
section 43(2) of the Consumer Guarantees
Act 1993 (“CGA”) it is agreed that the
provisions of the CGA do not apply. To
the fullest extent permitted by law in New
Zealand, Quik Corp excludes any liability
for any direct or indirect loss or damage of
any kind arising from the Product, including
consequential loss or damage or loss of
profits, and loss or damage arising from
the negligence of Quik Corp’s employees
and agents. The warranty is personal to
the Customer and cannot be transferred
to a subsequent purchaser (although the
purchaser, in some circumstances, may
have rights under the CGA or the Sale
of Goods Act). These exclusions do not
exclude Quik Corp’s liability in respect of
any warranties or guarantees implied by
any relevant legislation in New Zealand
which cannot legally be contracted out of.
7. Warranty Claim Procedure
7.1.
To obtain warranty service:
9
WARRANTY POLICY