Operation Manual - Security
Quidway S3000 Series Ethernet Switches
Chapter 1 802.1x Configuration
1-6
Table 1-4
Check the users that log on the switch via proxy
Operation
Command
Enable the check for access users via
proxy
dot1x supp-proxy-check
{
logoff
|
trap
}
[
interface
interface-list
]
Cancel the check for access users via
proxy
undo
dot1x supp-proxy-check
{
logoff
|
trap
}
[
interface
interface-list
]
By default, cancel the control method set for access 802.1x users via proxy.
1.2.5 Set Supplicant Number on a Port
The following commands are used for setting number of users allowed by 802.1x on
specified port. When no port is specified, all the ports accept the same number of
supplicants.
Perform the following configurations in system view or Ethernet port view.
Table 1-5
Set maximum number of users via specified port
Operation
Command
Set maximum number of users via
specified port
dot1x
max-user
user-number
[
interface
interface-list
]
Restore the maximum number of
users on the port to the default value
undo dot1x
max-user
[
interface
interface-list
]
By default, 802.1x allows up to 256 supplicants on each port for S3000 Series Ethernet
switches (except 64 for S3026).
1.2.6 Set to Enable DHCP to Launch Authentication
The following commands are used for setting whether 802.1x enables the Ethernet
switch to launch the user ID authentication when the user runs DHCP and applies for
dynamic IP addresses.
Perform the following configurations in system view.
Table 1-6
Set to enable DHCP to launch authentication
Operation
Command
Enable DHCP to launch authentication
dot1x
dhcp-launch
Disable DHCP to launch authentication
undo dot1x
dhcp-launch
