33
Quicksilver 875SD — System & Component Overview and Operation
Fuel burning open flame appliances consume cabin oxygen
and release products of combustion into the craft.
Ventilation is required when appliances are in use. Open
designated vent openings while appliances are in use. Do
not use the stove or oven space heating. Never obstruct
ventilation openings.
Do not use solutions containing Ammonia
Never use flames to check for leaks
system is present.
IF PRESSURE GAUGE READING FALLS, LEAK IS PRESENT. DO NOT USE LPG
APPLIANCES.
2.
Routine observation of bubble leak detector (if fitted on the system).
3.
Manual leak testing with foam
-
producing, soapy water or detergent solutions (with appliance
burner valves closed and cylinder and system valves open); foam
-
producing solutions for leak
detection on gas installations in accordance with EN 14291 meet these requirements.
If a leak is present, shut off the LPG supply at the main supply valve. Extinguish any open flames
(heaters, stoves, etc.) and do not operate any electric switches. Finally, evacuate the area if possible.
Quicksilver® recommends that any LPG system repairs should be made by your authorized
Quicksilver® dealer.
Do not use an LPG system that has leaked until it has been
inspected and repaired by a competent person.
If a leak is detected, shut off the main LPG supply valve and
do not use LPG appliances
Changing LPG Cylinders
To replace empty LPG cylinder:
1.
Turn off the stove and close the shutoff valve.
2.
Close the valve on the LPG cylinder.
3.
Remove the regulator by turning the nut clockwise.
4.
Replace the empty tank.
5.
Inspect the regulator. Make sure that the gasket located on the regulator nut is in good
condition. If not, replace regulator gasket or regulator itself.
6.
Re
-
install and tighten the regulator by turning the nut counterclockwise.
7.
Check for any leaks before restarting the stove.
9.
Electric Grill (optional)
Instead of an LPG system, an electric grill option is available at the cockpit entertainment center. The
electric grill is powered by shore power, and the COOK TOP breaker on the shore power panel must
be ON for the grill to function.
A concealed electric element eliminates grease flare
-
ups and a reusable grease pan located under
the heating element collects all the fat and juices associated with grilling.
The grease pan must be
emptied after each use.
To remove the grease pan:
1.
Remove the grate
2.
Lift the heating element
3.
Remove the grease pan
When replacing the pan, assure that it is completely contained within the grill and that the side of the
pan does not extend outside of the grill sides.
Summary of Contents for 875SD
