Quicksilver 675CR, Owner'S Manual

Page: 47 / 55

Quicksilver 675CR— Electrical Systems
35
5. Fuses and Breakers
Your boat will either have fuses or breakers protecting the DC electrical system. If you have to replace
a fuse or electrical breaker, replace only with a fuse or breaker of the same rating. The amperage will
be marked on the fuse or breaker, and it is recommended that you carry spare fuses or breakers.
Use only fuses and breakers having the same amperage
rating as the original or as specified. Use of higher
amperage fuses or breakers is a fire hazard.
If a fuse or breaker is replaced with one that has a lower amperage, it may not be sufficient to carry
the electrical load of the equipment it is connected to and will cause nuisance failures. If a fuse or
breaker is replaced with one that has a higher amperage, it will not provide protection against an
electrical malfunction and could create a possible fire hazard.
The 675CR has a breaker panel at the helm, located below the steering wheel. There is also additional
breakers located on the battery switch panel in the cockpit seat storage tub
Battery Panel
Trim tab breaker — 15 Amp
Waste pump breaker—20 Amp
Main breaker — 40 Amp
Windlass breaker — 60 Amp
Fuses and breakers
ATO/ATC fuse Thermal breaker ANL fuse Magnetic breaker
Panel location
Battery switch
Aft bilge breaker—3 Amp
Forward bilge breaker — 3 Amp
Spare breaker—10 Amp
CO monitor breaker — 5 Amp