Quicksilver 605 Pilothouse, Owner'S Manual

Page: 38 / 54

26
Quicksilver 605PH — System & Component Overview and Operation
release it from the shut-off switch, which in turn shuts down the engine. This switch is designed to
shut the engine off when the operator of the boat leaves the control station, either accidently by
falling into the boat, or by being ejected overboard.
The lanyard should be long enough to prevent inadvertent activation. Do not let the lanyard become
entangled.
11. SmartCraft® System Gauges
The instrument package on your boat includes a SmartCraft® tachometer and speedometer multi-
gauge system. By pressing the “mode” button on the gauge, specific information vital to the safe
operation of the vessel can be displayed. Refer to your SmartCraft® gauge owner’s manual for specific
information on how to get the most out of the multi-gauge display.
12. Exterior Helm (optional)
An optional exterior helm is available which allows for low speed operation of your boat while in the
cockpit. The exterior helm, located on the forward starboard side of the cockpit consists of a steering
wheel, a hydraulic helm pump, and a mechanical gear shift/throttle control unit. In addition, the gear
& throttle mechanisms are located in the cockpit bilge, and a helm selector switch is located at the
main helm.
Operation
At the main helm (located inside the cabin) there is a helm selector switch located on the starboard
side, under the control unit. The helm selector switch mechanically “locks out” the control unit to
make sure that you can only control the engine from one helm. The gear & throttle mechanisms are
located in the cockpit bilge.
Helm Control Transfer
When the switch is in horizontal position, the control is set to be at the main helm. To switch control
from the main helm to the exterior helm, pull out and rotate the handle clockwise 90 degrees until it
locks into position. You will now have control of the engine at the exterior helm. To return control
back to the main helm, pull out and rotate the handle counter-clockwise 90 degrees until it locks into
position.
Mechanical Control
Engine trim
“Throttle Only” button
Ignition shutdown safety switch
Wear the lanyard at all times when operating the boat. Use
it to stop the engine only in an emergency. DO NOT use it to
shut off the engine during normal operation