Quicksilver 2M 70CM, User Manual

Page: 57 / 62

51
acknowledge the remote tran sceivers are ready for
programming. The master radio would then initiate
the change using the instructions in Step 6 below.
Once programming is complete, the icon “
” will
disappear. If it does not disappear, programming
was not successful. Once programming is
successful, the remote users can switch to the newly
programmed channel.
6) Changing operation: On the master transceiver,
press the Call key (“A” on the DTMF microphone).
“Send 01” appears on the screen. Use the
“CHA+/CHA-“ or “VOL+/VOL-“ keys to select
the channel you wish to program, such as Channel
003, then press the PTT key. Press the “A” key
again. This will display “Send 03”. Press the PTT
to send the second programming code. If the icon
“ ” disappears, programming was successful.
RX Inhibit/RXTX Inhibit
RX Inhibition:
When RX Inhibit is enabled, the
receiver will be inactive until the correct RX Enable
code is received. While the transceiver is in RX
Inhibit mode, pressing the PTT key will also produce
an error tone.
RXTX Inhibition:
When RX/TX Inhibit is enabled,
the transceiver will remain completely inactive; it will