15
Rotate the axle bracket (Standard)
Using the quick-release axles, take the wheels out of the
angle adapter.
Undo the screws (1) and remove the axle brackets (2) on
both sides of the wheelchair. Rotate the axle bracket by
180° and refit it into the axle stem (3) on the opposite
side. Please note that the axle bracket has an
asymmetrical shape. The adjustment offers changes in
the centre of gravity in 2 cm steps. Use the given torque
(Fig. 26/27).
In addition, the standard adapter offers a second position
for fitting the angle adapter. When the wheelchair is
delivered, this position is covered with a sleeve. To use
this position, please undo the two screws (1). Then swap
the axle adapter (4) and the sleeve (5) and re-tighten both
Allen screws (1), (Fig. 26/27). Please note that the key
surfaces on the axle adapter should always point inwards
and select the wheelbase as desired (see width
adjustment of the rear wheelbase). Use the given torque.
For centre of gravity adjustment, please see the technical
specifications section at the end of these Directions for
use.
Rotate the axle bracket (lightweight)
Using the quick-release axles, take the wheels out of the
angle adapter.
Undo the screw (1) and remove the axle brackets (2) on
both sides of the wheelchair. Rotate the axle bracket by
180° and refit it into the axle stem (3) on the opposite
side. Please note that the axle bracket has an
asymmetrical shape. The nut surface (4) must always
face outwards. The adjustment offers changes in the
centre of gravity in 2 cm steps. Always use the given
torque (Fig. 28/29).
Fig. 26
1
Fig. 27
2
3
4
5
Fig. 28
1
Fig. 29
2
3
4
