931134 Rev. A
I X . S e t - u p & A d j u s t m e n t
37
I X . S e t - u p & A d j u s t m e n t
931134 Rev. A
36
P. FRAME DEPTH
1. Back adjustment
a. Loosen and remove the front bolt (F) located in
front of back mounting plate and use it to
secure the angle of the backrest using position
G in the saddle (underneath the side rail).
b. Loosen and remove the rear bolt (H) from the
back mounting plate.
c. Repeat both steps on the other side.
d. Slide the backrest along the seat rail to the
desired position.
e. Replace and tighten the rear bolt (H).
f. Remove the front bolt from position G and
insert it in its original location.
g. Repeat on the other side.
IMPORTANT NOTE–
The adjustment on each side of the
chair should be exactly equal.
NOTE–
Use a torque setting of 240 in.-lbs. When set-
ting-up back depth adjustment.
2 Hanger Receiver Adjustment
a. Loosen and remove both socket head screws (A)
from the seat rail.
b. Slide the hanger receiver (B) in the seat rail to
the desired position.
c. Replace and tighten the socket head screws.
d. Repeat on the other side.
IMPORTANT NOTE–
These adjustments may also require
re-positioning the carriage over the base frame, refer to
matrix in the ordering guide for recommended location.
NOTE–
Use a torque setting of 240 in.-lbs. When set-
ting-up hanger receiver.
A
B
2. Angle Adjustment of the Stroller Handle
Depress both black push buttons (H) at the same time.
This disengages the stroller handle and allows it to
rotate freely. Releasing the push buttons positively locks
the adjustable stroller handle in the desired position.
3. Height Adjustment
a. Remove both bolts (I) from the backrest tube
(one on each side).
b. Reposition backrest height.
c. Re-tighten both bolts (I) in the desired location.
4. Flip-Down Back Function
a. To fold the back down, pull-up the back release
pins (A) and push the backrest forward.
b. To lock it back in position, lift the backrest
firmly until it locks in its original position.
N. STROLLER HANDLE EXTENSION (OPTIONAL)
Installation
a. Press button (B) on the stroller handle so that
release pins are drawn inside the tube.
b. Insert the tube into the back tube receiver (C)
until the release pin protrudes through the
receiver mounting hole.
O. RECLINING BACK
The dual trigger reclining mechanism is installed by
Sunrise.
1. To Recline or Raise Backrest
a. Depress both triggers (D) at the same time.
Releasing the triggers positively locks the back-
rest in place within its 60° range.
b. To lock out the adjustment system, insert the
locking pin (E) into the trigger holder. Always
lock the dual trigger reclining mechanism
securely in place after positioning the backrest.
A
B
C
D
E
G
H
I
F
G
H
F
H
