7
Fitting the door
- First assemble the door using 4 x elbow fittings, 2 x 1.8m poles and 2 x .60m
poles. Slide 2 x hinge eyes onto one of the 1.8m poles. The door can now be hung on the hinge
pegs previously installed by locking the pegs at the correct height and adjusting the eye fittings
on the door to suit. If the door is not hanging square this can be remedied by slackening the
elbow joints and adjusting the poles. The door is 20 cm shorter than the uprights to allow for
uneven ground under the door. Fit the door snug with the roof bar above, the gap below is
closed with the door mesh.
To install the pole for the door to close against offer it up against the door for correct positioning
and sink in the ground in the same manner as the other uprights. Slide a hook fitting over the
pole before the top is fixed into the short tee fitting on the roof bar above.
