XRSeries
EN
90°
HYDRO
90°
90°
90°
45°
D
E
F
H
G
45°
AC
I
L
QUICK
XRSeries
INSTALLATION AND USER’S MANUAL - REV000A
10
4 - Installation
XR7/XR8
•
C)
Position the upper part of the windlass.
D)
Secure it by screwing the nuts on the locking studs.
E)
Insert the O-ring into the flange.
F)
Secure the flange to the base insert with 6 screws.
G)
Insert the gearmotor into the
windlass shaft.
H)
Tighten with screws.
XR9
•
C)
Position the upper part of the windlass.
D)
Secure it by screwing the nuts on the locking studs.
I)
Insert the gearmotor into the windlass shaft.
L)
Tighten with screws.
WASHER
SCREW
Nm
Nm
O-RING
WASHER
STUD
GROWER
NUT
FLANGE
SCREW
BASE INSERT
C
WASHER
SCREW
GROWER
Tighten screws and nuts following a cross pattern with reference to the tightening values shown in the table (page
7). Apply threadlocker on the screws supplied. Periodically check proper tightening of screws.
ELECTRIC MOTOR
Connect the power cables coming from the windlass to the mains (AC).
HYDRAULIC MOTOR
Connect the pipes coming from the distribution valve to the two hydraulic motor flanges
(see wiring diagram on page --).
WARNING:
before connecting the equipment, make sure that cables are not live.
HORIZONTAL POSITION OF GEARMOTOR AND HYDRAULIC MOTOR
ELECTRIC
Depending on the type of gearmotor, a rotation every 45° or 90° is possible.
HYDRAULIC
Depending on the type of motor, a rotation every 90° is possible.
The entire XR series features the
band brake with movable fixing
block that allows to aim the
handwheel in several positions
on the deck plan.
