15
EN
SBC NRG
+
MEDIUM IT EN REV000A
INSTALLATION
INSTALLATION SITE
Install the battery charger as close as possible to the batteries in a dry and airy spot, to allow the correct operation of
the device at full power.
The battery charger can be installed on a horizontal surface or vertical wall paying attention that the output connector
faces downwards.
The battery charger must be fixed to the support surface with screws strong enough to support its weight, paying atten-
tion that they do not weaken or cause cracks to the boat structure.
Vertical installation is recommended since the natural convection of the heat will favour the cooling of the device.
The perimeter of the battery charger (excluding the support base) must be kept at a distance from walls or objects by a
minimum of 5 cm.
WARNING:
the battery charger must be used only with re-chargeable lead/liquid electrolytic batteries (open or
sealed), Gel, AGM, Optima
®
, Li-Ion.
WARNING:
the battery charger can not be used to recharge non rechargeable batteries.
NECESSARY EQUIPMENT FOR INSTALLATION
Depending upon model, use the batteries and cables on the output terminals as specified in the following table:
MODEL
SBC 600 NRG+ FR
SBC 700 NRG+ FR
SBC 750 NRG+ FR
SBC 950 NRG+ FR
Battery voltage
12 V
24 V
Battery capacity
230 ÷ 500 Ah
270 ÷ 600 Ah
140 ÷ 300 Ah
180 ÷ 400 Ah
Minimum output cable size
16 mm
2
25 mm
2
10 mm
2
16 mm
2
Number of battery cells
6
12
The wires connected to the output terminals must have a maximum length of 4 meters.
5 cm
5 cm
5 cm
5 cm
CONNECTOR
Summary of Contents for SBC 600 NRG+ FR
Page 2: ......
Page 25: ...25 25 SBC NRG MEDIUM IT EN REV000A SBC NRG SERIES SBC NRG 12V SBC NRG 24V ...
Page 26: ...NOTES ...
Page 27: ......