USER MANUAL
7
2.5.1.
Steps of removing the Heater
1) Pull out the
①
Soldering tip and screw down the
⑤
Nipple
2) Pull out the
⑥
Heater from the
⑪
Handle body
3) Pull out the
⑩
Wire clamp from the
⑨
Plastic part upward
4) Unplug the three leads plugged into the heater pin
5) Remove the
⑨
Plastic part,
⑧
Spring and
⑦
Grounding spring
NOTE: All operating steps are performed with the power
disconnected and the handle cooled.
2.5.2.
Steps of replacing the Heater
1) Plug the three wires into the
⑥
Heater pins
2) Install the
⑧
Spring and the
⑦
Grounding spring, and snap the
⑩
Wire clamp into the
⑨
Plastic part
3) Put
⑥
Heater into
⑪
Handle body
4) Screw on
⑤
Nipple and Install
①
Soldering tip
5) Put
②
Tip enclosure and
③
Nut on
⑤
Nipple and screw them tightly
6) After replacing the heater, the following measurements are
recommended:
7) Calibrate the
temperature, refer to
Soldering temperature
calibration.
