MOD. 0980 - 0990 - 0995
QUICK MILL
20
tap and discharge all the steam. Turn the machine on again and leave
the steam tap open
8
. If the pump does not start operating automatically,
discharge a little bit of hot water from the hot water nozzle
11
or from
the unit
1
until the pump starts working again.
The boiler is refilled and the air remaining in the boiler is discharged via
the steam nozzle. When you no longer hear noises coming from the
pump, close the steam tap
8
again. The machine is now in the heating
phase. When the green machine-ready light
12
turns on, the machine
is ready to use. It is of no importance if the control light turns on during
operation. The machine maintains the operating temperature constant.
6 TRADITIONAL COFFEE DISPENSING
Do not remove the filter holder while the coffee is being
dispensed. Danger of burns.
MOD. 0980 - 0990 - 0995
1. Use the one-cup or two-cup filter holder with the relative filters.
2. Fill the ground coffee filter using the measuring cup provided and
press down the coffee.
3. Insert the filter holder in the lodging of the dispensing unit
1
and turn
in a counter clockwise direction
4. Depending on which filter is used, place one or two cups under the
filter holder.
5. Move the coffee dispensing lever upwards
6
.
6. When the desired amount of coffee has been dispensed, pull the lever
6
downwards (the unit’s valve will discharge the excess water into the
drip tray
13
.
IMPORTANT:
If the coffee dispensing lever is not completely in the
downward position, spurts of steam and water will be released when the
filter holder is removed.
Therefore, it is very important that the lever is completely in the
downward position after the coffee has been prepared.
-Cream will not form in the cup if the coffee comes out too quickly. In this
case, use finely ground coffee or try pressing the coffee down hard to
reduce the brewing speed.
-If the coffee comes out in drops, use courser ground coffee and press
down lightly on the coffee.
The dispensing should take around 20/25 seconds.
To prepare a coffee at the right temperature, wait for the
machine to heat up (at least five minutes) before dispensing
the coffee. Leave the filter holder in its lodging.
7 HOT WATER DISPENSING
Spurts of hot water may be verified at the beginning of the
dispensing process.
The tube may become very hot, do not touch the parts that
do not come with the anti-burn rubber. Danger of burns
The appliance must be ready to use as indicated in paragraph
5.4
MOD. 0980 - 0990 - 0995
1. Place a container under the hot water nozzle
11
.
2. Turn the knob of the hot water tap
9
in a counter clockwise direction.
You will instantly obtain the desired water jet.
IMPORTANT:
The water dispensing tube must be positioned deep into the
container to prevent water from spurting, thus causing burns.
Istruzioni 0980-0990-0995 27-02-2007 8:51 Pagina 19
