HPi
110 &
HPi
210
Quick Rig (QR) Systems
User Manual
HPi110 & HPi210 Quick Rig (QR) Systems
7
Mounting The Speaker & Rigging System
Installation of the Spine on the HPi110
NOTE: The 2 x M10 bolts supplied with both the i-Spine and t-Spine should replace the previously
installed screws in the speaker . The M10 bolts are designed with a longer thread which provides
increased strength and security to the system .
Remove the 2 top
screws that are
installed in the speaker
then insert the lip of
the Spine to grab the
casing handle .
1
Swing it flat on the
top of the speaker .
2
Bolt in and secure
(using Loctite or similar
fastener securing
compound) the Spine
onto the speaker with
the 2 x M10 bolts
included .
3
Installing an HPi110 becomes incredibly easy
with the QR wall-mounting system .
Once the spine has been installed (as
described above) install the wall-mount as
follows:
1 . Bolt the wall mount assembly (without
the speaker attached) onto the wall .
2 . Lift the speaker (now installed with
Spine) and hook it onto the wall-mount .
The wall-mount is designed to safely
support the weight of the box from this
point .
3 . Set the angle by sliding the quick-pin
into the right hole (see next section for
angles) .
HPi110 with
i-Spine
Fixed hook
assembly
