Quell
®
User Manual Quell Customer Care 1-800-204-6577
<
Contents |
10
Chapter 4: Calibration
Before you begin using your device for the first time you will need to calibrate. You should also
recalibrate your device if you are no longer experiencing pain relief.
Otherwise you do not need
to recalibrate your device
, including when you switch electrodes and alternate legs.
You should carry out the calibration process in a quiet area without distractions. Make sure
you are using a new electrode. Sit with foot flat on the floor and leg at a 90 degree angle.
Calibration won't start if leg is extended horizontally.
Chapter 4
Calibration
1. Snap a new electrode onto the connectors.
2. Carefully remove liner and
place your Quell
band directly on your upper calf
approximately
1 to 2 inches below knee of either leg. Lights
should face up.
3.
Hold the button
until you see the lights running
back and forth then release the button.
Every time you feel the slightest tingling
sensation, click the button once.
The sensation
will pause each time you click the button.
When the sensation starts again, click the
button again.
You will typically click the button
3-6 times.
When the lights go off, calibration is complete.
If you need to halt the calibration process at any
point just click the button 4 times in sequence.
If you halt the calibration process before it is
completed, you will have to re-start and fully
complete the calibration process before using
your device.
Device is calibrated for a single person and should
not be shared.
