Motion detection
-
Press the ‘Mode’ button for about 3 seconds. The blue/red LED is
flashing three times and the motion detection becomes directly active. During the recording, the LED is off. The camera will now
record a sequence of a minimum of 1 minute. As long as a movement is detected the camera will continuously record (up to 5
minutes sequences maximum). After saving this sequence, the camera will stop recording. The LED is still off, but the motion
detection mode remains activated. Once a new movement is detected, the camera begins again to record as long as a
movement is detected (5 minutes sequence max). A new movement detection is reported by a short blue/red flashing LED. Stop
the detection mode by pressing the on/off button. To power off the camera, (in standby or motion detection mode), push and
hold the on/off button until a fast blinking blue LED is visible. After that the LED goes off and the camera is turned off
Power the camera and wait until the blue LED is lighting.
Note : the camera will continuously record 5 minutes sequences for both 720p and 1080p modes. When the SD-card is full, the
camera will automatically loop and delete the oldest file. When the battery is nearly empty, the camera will automatically save the
last sequence and power the device off.
Photo shooting
-
In standby mode (blue LED is lighting), change to
by using the ‘Mode’ button. Push two times the ‘Mode’ button,
the LED is turning from blue to blue/red and than to red. Take a
by pressing the on/off button.The red LED is briefly going
off, than returns to solid red. A photo was taken. To return to video mode, push one time the ‘Mode’ button. The LED is showing
again a solid blue.To power off the camera, (in photo or video mode),push and hold the on/off button until a fast blinking blue
LED is visible. After that the LED goes off and the camera is turned off.
Photo Mode
Photo
Dashcam use
- You can use the A3s as a dashcam. If connected to a USB car socket, the camera will start automatically and record a 720p
video when you turn on the engine. If you want the camera to record in 1080p, you have first to turn on the camera and change
to 1080p video before connecting the camera to the power source, else it will not work. In both modes (720p and 1080p) the
camera will create sequences of 5 minutes each. When the capacity of the SD card is reached, it will overwrite the oldest record
and continue recording a new sequence. When you turn off the engine, no matter which mode you have chosen, the camera will
record the last sequence and turn off the device.
4/7
720p motion detection
