QubicaAMF XLi EDGE Series, Service & Parts Manual, Page: 39 / 260

Section 3
.
Pinspotter Mechanical Operation
400-088-120-02 Page 3-15 Rev. Date: 10/2016
3.2.9 Pin Deck Light Operation
The QubicaAMF XLi EDGE Pinspotter is equipped with a 110/220-volt, 50/60-hertz
LED pin deck light (see Figure 3-15 for dimmer box and pin deck light rating,
certification, and caution labels) that can be used to provide normal (daylight)
illumination or color illumination with one of many preset color choices, as desired.
Figure 3-15
The system is made up of the following components:

LED Pin Deck Light Fixture

DMX Dimmer 2 Unit

Bracket Kit

Dimmer Cable

Ground Cable

Dimmer Comm Cable

Cat5 Daisy Chain Cable (24 AWG wire)

Power Cord

XLi Handheld Splitter (for XLi pinspotters only)
The bracket holds the light fixture in place. The dimmer 2 unit provides power to the
LEDs as directed by the pinspotter chassis (via the handheld splitter).
The pin deck light for each pinspotter can be switched to select white or colored
light independently of any other pinspotter. This can be done from the Chassis, the
MCU, or from the handheld unit using the Settings Menu. Refer to the XLi Control
Chassis Manual, 400-088-009 and the Manager’s Control Unit Manual, 400-088-051,
for specifics on pin deck light operation. An overview for the Pin Deck Light
installation is shown in Figure 3-16 on the next page, and pin deck light replacement
parts are shown in Section 5 of this manual
.
If the pin deck light fails to operate, check that it is plugged in.