QubicaAMF XLi EDGE Series, Service & Parts Manual, Page: 21 / 260

Section 2
.
Safety
400-088-120-02 Page 2-5 Rev. Date: 10/2016
7
9
7
6
3
5
6
8
4
10
2
1
2.3 Safety Guards
For pinspotters equipped with the SmartGuard™ Safety System, refer to the XLi EDGE SmartGuard
Safety System Manual, 400-088-092, for additional information concerning the function and operation
of the safety system as well as for additional safety requirements and lock-out / tag-out instructions.
All safety guards must be in place before operating the machine. When maintenance is required, the
following steps must be followed.
1. Place the Sweep in the First Guard position.
2.
Turn off the logic and machine power breakers on the Control Chassis.
3.
Disconnect the power plugs from the top of the Control Chassis.
4.
Lock out and tag out power to the pinspotter in accordance with your facility’s established
procedures.
5. Remove guards only as required to perform the maintenance.
6.
Once maintenance is complete, replace all guards.
There are six different types of safety guards and several labels on a standard pair of QubicaAMF
Pinspotters (refer to Figure 2-2):
1. Center Screen Guards 6. Hand Rails
2. Ball Lift Screen Guard 7. Warning Label (Distributor Support)
3. PBL Top Guard 8. Warning Decal (Yoke)
4. End Guard Panel 9. EDGE Logo Decal
5. Chassis Cover Guard (behind Chassis) 10. End Guard Danger Label
Figure 2-2
9
10
7
8