Safety
QubEV
QUBEV-UG-02 Installation and Operation Manual
Page
4
of
15
November 2020
Safety
This manual is specifically applicable to the QubEV electric vehicle charging product and is
provided as a guide to its installation and operation.
Failure to install and operate the QubEV in accordance with these instructions may damage the
unit and invalidate the manufacturer’s warranty.
WARNING: Electrical Power
Make sure electrical power is isolated BEFORE starting this procedure.
x
Turn power OFF at SOURCE.
IMPORTANT:
Installers and End Users
must
read and
understand
the content of
this manual before installation and/or use of the product.
Installation must
only
be performed by someone who is properly qualified and competent to do
so in accordance with the current legislation in force in the geographical location of the
installation.
x
If the advice in this manual is not understood, contact the distributor for further advice
and/or training BEFORE attempting installation/operation of the equipment.
x
The manufacturer/distributor cannot accept any responsibility for improper installation or
any problems arising from improper installation.
NOTE:
Damage to the equipment, connected systems or to property caused by improper
installation are the responsibility of the installer.
x
The information provided in this manual must ONLY be used with the model(s) listed on page
2 of this manual.
x
The information provided in this manual must NOT be used with any other product.
x
The content of this manual may be updated as required.
x
Do NOT use the equipment for anything other than its intended purpose.
x
Do NOT modify the equipment unless specifically instructed to do so by the manufacturer.
x
Do NOT attempt to repair the equipment unless specifically instructed to do so by the
manufacturer.
x
To maintain electrical safety, the body enclosure of the product (access covers) must be
secured in their correct location using the supplied fasteners and the seal must be sufficient
to maintain the IP rating of the enclosure.
x
Fasteners used to mount the product in its working location must be sufficient for the task
and the specific mounting point.
x
If required, fasteners used to mount the product in its working location should be sealed to
maintain the IP rating of the enclosure.
x
Cable entry apertures should be sealed with an appropriate cable gland(s) to maintain the IP
rating of the enclosure.
x
Damage to the body enclosure, access covers, seals may render the product unsafe. The
product must be electrically isolated and NOT used until appropriate remedial action has
been performed.
Product Specification
QUBEV-UG-02 Installation and Operation Manual
QubEV
September 2020
Page
5
of
15
Safety Advice within this Manual
This manual uses a system of warnings, cautions and notes.
x
WARNINGS
concern the safety of installers/end user and will be given before the
detail/instructions in the manual.
x
CAUTIONS
concern the potential for damage to the equipment and will be given before the
detail/instructions in the manual.
x
NOTES
are given to provide additional information and/or to highlight information of
importance. They will be given either before or after the detail/instructions as appropriate
and may use different wording (such as IMPORTANT) where emphasis is required.
Warnings, Cautions and Notes may be repeated several times as appropriate and may be
preceded by a hazard symbol where appropriate.
Product Specification
Physical Specification
Dimensions
150mm x 200mm x 100mm (W x H x D)
Materials
ABS (UL94 HB Fire Rated), IK08
Mass
<2.0kg
Operating Temperature
-20°C to +50°C
Protection
IP65 - Enclosure, IP54 - Socket
Figure 1 General Arrangement and Dimensions
