PiXtend
Construction manual:
PiXtend V1.3 Full
Kit Assembly
3. Connecting PiXtend and Raspberry Pi
The connection of the Raspberry Pi and the PiXtend is done quickly.
The 26/40-pole flat ribbon cable with pre-fabricated connectors is getting plugged on the
PiXtend first. Because of the “nose” of the connector it is not possible to plug it wrong.
For the beginning the cable is getting bent away from the PiXtend- board (Figure 78) that it
doesn't disturb at the montage of the Raspberry.
As next step the Raspberry Pi can be screwed on the four 25 mm spacers (4x M2,5x6 mm
screw). Therefore is needed a little cross recess screw driver.
On the following page you will find a picture with correct aligned Raspberry Pi and a mark
of the four screws.
www.pixtend.de
Copyright by Qube Solutions UG (limited liability)
72 / 75
Figure 78: Plugging the flat ribbon cable to the PiXtend
