Quax nv
Karel Picquélaan 84 B-9800 Deinze Belgium
T
T
0032 9 380 80 95 www.quax.eu -
E
E
COCOON
54F01-0300x
33
Step 4.9
: Use the parts from step
4.8
, the drawer backs
14
,
15
and
21
, fourteen wood screws
C
, the drawer bottoms
18
and
19
, ten wood screws
I
, the rest of the slider parts
L
and eighteen wood screws
B
.
Place the drawer backs (
14
,
15
and
21
) between the drawer sides. Push the wood screws (
C
) in the holes at the rear
outside of the drawer sides and tighten them in the backs. Push the drawer fronts with their connectors into the drillings
and over the wooden dowels of the drawer sides. Tighten the mini
fi
x. Fix the bottoms (
18
and
19
) at the bottom of the
drawers using the wood screws (
I
). Place the inner slider parts on the holes of the drawer sides. Attach each slider with
three wood screws (
B
). Push the reinforcement bar (
20
) with its wooden dowel into the hole and over the connector of
the lower large drawer. Tighten the mini
fi
x. Push two wood screws (
C
) in the drillings at the back of the outside of the
reinforcement lath and tighten them in the drawer back.
Step 4.10 - Installing the drawers
: Use the assembled parts of step
4.7
and
4.9
Please start with the bottom drawer. Pull the sliders out of the furniture, place the assembled drawer against the rear stop
on the sliders and push the drawer over the front stop of the sliders. Repeat with the middle and lastly the top drawer.
The eventual gap between the drawers can be adjusted by slightly moving the sliders.
The drawers must be moun-
ted at right angles. check if
the drawer fronts are perpen-
dicular to the sides and not
oblique, as this can hinder
the drawer operation.
