QF150S; edition 2016-05; page 3 of 19
1. General
1.1. Introduction
These operating instructions are valid for the Quattroflow 150S pump.
No liability will be undertaken for any damages caused by non-compliance with the operating
instructions and service conditions! Original spare parts serve safety purposes. The use of other parts
may cancel the liability for the consequences and secondary failures resulting thereof.
Manufacturer: ALMATEC Maschinenbau GmbH
Carl-Friedrich-Gauss-Str. 5
47475 Kamp-Lintfort, Germany
Phone: +49 2842 961-0
Fax: +49 2842 961-40
e-mail: [email protected]
Internet: www.quattroflow.com
Quattroflow quaternary diaphragm pumps are constructed according to the state of the art and they
are reliable. Imminent danger by operating error or misuse can lead to damages of properties and/or
persons. The pumps are to be applied for the intended use and in a safety-related proper condition
only.
1.2. Storage
In general the Quattroflow pump is delivered operational and packaged. If the unit is not installed right
away, proper storage conditions are important for a trouble free operation later. The pump has to be
protected from wetness, coldness, dirtying, UV-radiation and mechanical influences. The following
storage conditions are recommended:
- Steady ventilated, dust and vibration free storage room
- Ambient temperature between 15°C (59°F) and 25°C (77°F) with a relative humidity below 65%
- Prevention of direct thermal influences (sun, heating)
1.3. Labelling of the pump
The ALMATEC Maschinenbau GmbH is certified as a modern, quality-orientated enterprise according
to DIN EN ISO 9001:2008 and 14001:2009. Before release for dispatch, any Quattroflow pump has to
undergo an extended final control. The performance data registered during this are archived in our
records and can be read back at any time.
As a general rule in the countries of the EU only such machines are allowed to take into operation,
which are determined to meet the regulations of the EU machinery directive, the harmonized
standards, European standards and the respective national standards. Hence the operator has to
verify whether the Quattroflow pump manufactured and delivered properly according to the customers
order meets the mentioned requirements.
Therefore make sure, before putting the pump into operation, that the pump and the used materials of
construction are suitable for the provided application and the installation site.
The type label of each Quattroflow pump can be seen on the bottom of the base plate. Besides the
serial number of the pump head is fixed at the front cover.
