4
5
2. Turn off the mains cold water feed to the
water heater Inlet.
3. Connect the CO2 bottle to the regulator
found on the front of the water heater unit.
Listen for gas escaping and keep twisting the
bottle until it stops. Stop when the bottle is
hand tight.
5. Now re-open the mains cold water supply
to the water heater Inlet.
6. Activate the sparkling function on the tap
and allow water to run.
7. While the water is running, turn on the
chiller carbonator. The pump will turn on, and
you will hear it.
8. Deactivate the Sparkling option.
9. Activate the sparkling option again for a
couple of seconds and then deactivate.
10. The compressor and fan in the chiller unit
will continue to run until the temperature is
reached. This should take approx. 5-10 min-
utes depending upon the temperature of the
incoming mains water supply.
11. When the fan and compressor have
stopped, activate the sparkling function again
and run off one (1) glassful of water. Deacti-
vate the sparkling and wait for the pump to
stop.
NOTE:
If you don’t hear the air escaping,
there’s no gas in the bottle.
4.
DO NOT POWER UP YET.
• Run the Sparkling option on the tap until gas
comes out.
• Deactivate the Sparkling function
so that the pump can continue to feed pres-
surized water into the chamber where it mix-
es with the gas. The pump will be damaged if
it is starved of water (this is why the solenoid
has a delay).
If you hear the pump running beyond 20 sec-
onds simply activate the sparkling for 1-2 sec-
onds to open the solenoid.
DO NOT ALLOW
SYSTEM TO RUN DRY.
12. At this point, let’s look at the quality of the
water. Activate the sparkling water button.
You will hear the pump kick in letting you know
the system is working correctly.
When you turn off the sparkling function the
pump should turn off.
13. See if it is fizzy enough by tasting it. If not,
you will be able to adjust using the CO2 reg-
ulator.
We are going to wait now for a few minutes
until the chiller fan turns off - and the com-
pressor turns off until it drops to 40 degrees
Fahrenheit.
NOTE:
Do not go by what the water looks like
in the glass you need to taste it.
NOTE:
Listen for the pump to activate during
this process. The pump pressurizes the gas
into the water. Activating the sparkling func-
tion opens the solenoid that feeds water
into the chiller carbonator. When deselecting
sparkling, the inlet solenoid remains open for
30 seconds .
Repeat this process for two (2) more
glasses of water. (The saturation of CO2 is at
its optimum below 4degreesC.)
TURN ON
CHILLER
CHILLER
CHILLER
CO
2
