4
5
TAP FUNCTIONS:
SPARKLING WATER
CHANGING THE CO2 CANISTER
When the sparkling water tastes flat, it is nec-
essary to change the gas canister.
The integral CO2 gas canister is sited on the
left-hand side at the front of the unit (see dia-
gram opposite).
Please follow the instructions below to ensure
your CO2 canister is correctly installed:
1. To remove a canister, unscrew in a counter-
clockwise direction.
5. Rotate until you hear a hissing sound. This is
the gas being released from the canister. It is
important to keep screwing until you can no lon-
ger hear this hissing.
6. When the canister cannot be turned further,
it is safely connected. Do not turn the canister
any further, as this will damage the regulator.
7. Touch the glass icon button and runoff an
amount of sparkling water to re-calibrate
the system.
2. Locate the thread on the regulator where the
gas canister will connect.
3. Carefully present the canister, ensuring the
canister is supported.
4. Rotate the canister in a clockwise direction,
being careful not to cross thread the regulator.
**see next page illustration.
FRONT VIEW
Clockwise
CO
2
NOTE:
While removing a canister,
it is important to support
its weight to avoid the can-
ister dropping on the floor.
When attaching a new gas canister, hand tight-
en the gas cylinder firmly but do not overtight-
en.
NOTE:
Check by listening that gas is not escaping.
The regulator has an internal opaque white-col-
ored seal that should stay firmly in place. Old-
er models have a black o-ring. If these are re-
moved or fall out, the gas will escape.
The regulators have two crosshead screws at-
taching the regulator to the front panel.
These are tightened during manufacture and
should be checked periodically at service inter-
vals, if they come loose gas will escape.
SPARKLING WATER & CO2 CANISTER
SPARKLING WATER & CO2 CANISTER
FRONT VIEW
Counter-Clockwise
CO
2
FRONT VIEW
CO
2
REGULATOR THREAD
CO
2
