Quatech SPP-100, User Manual

Page: 11 / 59

2.1.1 Client Driver Installation
The following procedure is used to install the SPP-100 Client Driver:
1. Copy the file SPP100CL.SYS from the SPP-100 distribution
diskette onto the system's hard drive.
2. Using an ASCII text editor, open the system's CONFIG.SYS file
located in the root directory of the boot drive.
3. Locate the line(s) in the CONFIG.SYS file where the Card and
Socket Services software is installed.
4. AFTER the line(s) installing the Card and Socket Services
software, add the following line to the CONFIG.SYS file:
DEVICE = drive :\ path \SPP100CL.SYS options
where options are the SPP-100 Client Driver command line
options discussed on the following pages.
5. Save the CONFIG.SYS file and exit the text editor.
6. Insert the SPP-100 into one of the system's PCMCIA slots.
NOTE: Since the SPP-100 Client Driver supports "Hot Swapping",
it is not necessary to have the SPP-100 installed when booting the
system. By inserting the card before booting, however, the Client
Driver will report the adapter configuration during the boot
process thereby verifying the changes made to the CONFIG.SYS.
7. Reboot the system and note the message displayed when the
SPP-100 Client Driver is loaded. If the Client Driver reports an
"invalid command line option", correct the entry in the
CONFIG.SYS file and reboot the system again. If the Client
Driver reports "Card and Socket Services not found", a version
of Card and Socket Services must be installed on the system or
the SPP-100 Enabler program must be used to configure the
adapter. If the Client Driver reports the desired adapter
configuration, the installation process is complete and the
SPP-100 may be removed and / or inserted from the system as
desired. On each insertion into the PCMCIA socket, the
SPP-100 will be automatically reconfigured according to the
command line options.
SPP-100 User's Manual 2-3