2.1 QSP-100 Client Driver for DOS
In order to use the QSP-100 Client Driver, the system must be configured with Card and Socket
Services software. Card and Socket Services software is not provided with the QSP-100 but is
available from Quatech.
IMPORTANT:
Some versions of Card and Socket Services dated before 1993
do not support general purpose I/O cards. If after careful instal-
lation of the Client Driver the QSP-100 does not configure or
operate properly, an updated version of Card and Socket
Services may be required. Card and Socket Services software is
available from Quatech Inc.
2.2 Client Driver Installation
The following procedure is used to install the QSP-100 Client Driver:
1. Copy the file QSP100CL.SYS from the QSP-100 distribution Quatech COM CD onto
the system's hard drive.
2. Using an ASCII text editor, open the system's CONFIG.SYS file located in the root
directory of the boot drive.
3. Locate the line(s) in the CONFIG.SYS file where the Card and Socket Services
software is installed.
4.
AFTER
the line(s) installing the Card and Socket Services software, add the
following line to the CONFIG.SYS file:
DEVICE =
drive
:\
path
\QSP100CL.SYS
options
where
options
are the QSP-100 Client Driver command line options discussed
on the following pages.
5. Save the CONFIG.SYS file and exit the text editor.
QSP-100 Users Manual
6