2.1 DSP-100 Client Driver for DOS
In order to use the DSP-100 Client Driver, the system must be configured with Card and Socket
Services software. Card and Socket Services software is not provided with the DSP-100 but is
available from Quatech.
IMPORTANT:
Some versions of Card and Socket Services dated before 1993
do not support general purpose I/O cards. If after careful
installation of the Client Driver the adapter does not configure
or operate properly, an updated version of Card and Socket
Services may be required.
2.1.1 Client Driver Installation
The following procedure is used to install the DSP-100 Client Driver:
1. Copy the Client Driver from the DSP-100 distribution diskette onto the system's hard
drive.
2. Using an ASCII text editor, open the system's CONFIG.SYS file located in the root
directory of the boot drive.
3. Locate the line(s) in the CONFIG.SYS file where the Card and Socket Services
software is installed.
4.
AFTER
the line(s) installing the Card and Socket Services software, add the
following line to the CONFIG.SYS file:
DEVICE
=
drive
:\
path
\
DSP130CL.SYS
options
where
options
are the DSP-100 Client Driver
command line options discussed on the following pages.
5. Save the CONFIG.SYS file and exit the text editor.
6. Insert the DSP-100 into one of the system's PCMCIA slots.
NOTE:
Since the DSP-100 Client Driver supports "Hot Swapping", it is not necessary to
have the DSP-100 installed when booting the system. By inserting the card before
booting, however, the Client Driver will report the adapter configuration during the boot
process thereby verifying the changes made to the CONFIG.SYS.
7. Reboot the system and note the message displayed when the DSP-100 Client Driver is
loaded. If the Client Driver reports an "invalid command line option", correct the
entry in the CONFIG.SYS file and reboot the system again. If the Client Driver
reports "Card and Socket Services not found", a version of Card and Socket Services
must be installed on the system or the DSP-100 Enabler program must be used to
configure the adapter. If the Client Driver reports the desired adapter configuration,
the installation process is complete and the DSP-100 may be removed and/ or inserted
2-3
DSP-100
(Rev. G and later)
User’s Manual
Summary of Contents for DSP-100
