19
■
Confirm the Stored DTMF Numbers
1. Press the [*] key on the microphone keypad, then the LCD displays “A--”.
2. Enter the memory number (01~32), the LCD displays the stored number or its alias.
3. Press any key other than the [PTT], the LCD resumes the initial display.
■
Auto Dial
1. Press the [*] key on the microphone keypad, then the LCD displays “A”.
2. Enter the memory number (01~32), the LCD displays the stored number or its alias.
3. Press the [PTT], then the number is transmitted.
■
Clear Stored DTMF Numbers
1. Press the [#] key on the microphone keypad, then the LCD display
“
D-----
”
2. Press again the[#]key on the microphone keypad, then the LCD displays “Clear”.
3. Enter the memory number that to be cleared (01~32), To cancel this operation, please
press any key other than 0~9.
4. Press the [#] key on the microphone keypad, then the stored number is cleared.
■
Redial
1. Press the [*] key on the microphone keypad, the LCD displays “A”.
2. Press the [0] key twice, then the last dialed number (up to 16 digits) is dialed and
displayed on LCD.
3. Press the [PTT], the number is transmitted.
Note:
The redial memory is cleared once radio power off.
Call
Ⅰ
/Call
Ⅱ
Press the programmed Call
Ⅰ
/Call
Ⅱ
key to transmit the stored DTMF code, 2-Tone,
MDC1200 signaling, Safety check.
DTMF
If DTMF signaling is set on the current channel, press the programmed Call
Ⅰ
/Call
Ⅱ
key to transmit DTMF code.
Red LED solidly glows while encoding, and goes out when encoding ends.
2-Tone/MDC1200
If 2-Tone/MDC1200 signaling is set on the current channel, press the programmed
Call
Ⅰ
/Call
Ⅱ
key to transmit 2-Tone/MDC1200 signaling. Radios that set with match
2-Tone/MDC1200, can receive from you. The preset function will be performed when
radio receives an incoming signal that with match 2-Tone/MDC1200.
●
Red LED solidly glows while encoding; orange LED solidly glows until the preset
