Quantum SuperLoader3 Magazine and Magazine Blank Removal/Replacement Instructions
Document 81-81314-01 B01
October 2005
4
Replacing a Magazine or Magazine Blank
Removing a magazine using the front panel
0
1
On the front panel menu, scroll to
Commands
.
2
Press
Enter
on the front panel.
3
On the
Commands
submenu, scroll to
Eject
, and then press
Enter
on the
front panel.
4
On the
Eject
submenu, scroll to
Right Magazine
or
Left Magazine
,
depending on which magazine you want to eject, and then press
Enter
on
the front panel.
The magazine pops forward so that the front of the magazine is no longer
flush with the front panel.
5
With one hand, grasp the magazine by the handle and slide it forward to
remove. Place your other hand under the magazine to support it and
prevent it from falling.
Removing a Magazine
Blank
0
Your autoloader comes equipped with either two magazines, or one
magazine and one magazine blank. The autoloader will not function without
both magazine bays equipped with either a magazine or a magazine blank.
To remove a magazine blank:
1
Pull the magazine blank straight out.
2
Replace with another magazine blank or a cartridge magazine (see
Reinstalling a Magazine
).
Reinstalling a
Magazine
0
To install a cartridge magazine:
1
Grasp the magazine by the handle with one hand and support it
underneath with the other hand.
2
Slide the magazine into the magazine bay. Make sure you position the
magazine correctly; it should slide smoothly.
3
The magazine is correctly installed when you feel it click into place and
the front is flush with the front panel.
Installing a Magazine
Blank
0
To install a magazine blank:
1
Grasp the magazine blank by the handle with one hand and guide the
blank into the magazine bay.
Warning:
Insert the magazine slowly to avoid damaging internal
components or the autoloader.
